![]() We've also used next-server to point to the TFTP server we're using (which is the same host as our DHCP server, but doesn't need to be). Here we've configured the server to give out IP addresses from the range 192.168.0.70-100, set the default gateway to be 192.168.0.1 Question – Why are we using a static IP assignment?ĢA alt 2) Create /etc/nf with the following contents: This configuration says that the client PC should be informed that the file “pxelinux.0” is available. The only thing you need to change in the above, is the MAC address to match that of the NIC on your client box. Another thing to note is that we're reserving the private 192.168 subnet for this setup. To explain – the above configuration file sets up a DHCP server that will assign IP address 192.168.0.254 to your client box that has MAC address 04:4B:80:80:80:03 assigned to its PXE-boot capable NIC. Yum install tftp-server dhcp httpd syslinuxĪnswer Y to all dependency/installation questions.ġC) Disconnect the Raspberry Pi from the network.ĢA alt 1) Create /etc/nf with the following contents: Check that you have an internet connection ![]() The Raspberry Pi will act as the DCHP server, the tftp server, and the web server.įirst, you need to install all of the necessary software.ġA) Connect your Raspberry Pi to a network. This boot image will then instruct the PC to fetch the complete operating system from a web server. ![]() The PC connects to the tftp server and downloads the basic boot image. The DHCP server will assign an IP address to the PC and tell the PC the address of a tftp (trivial file transport protocol) server where a boot image is available. If a PC is configured to boot over the network, it will search the local network for a DHCP (Dynamic Host Configuration Protocol) server. It is also known as net booting or LAN13 booting. PXE (Preboot eXecution Environment) is a method to allow a PC without a hard disk to boot from the network. Join computers together using ethernet cables.Find and download a boot CD image from the internet (easier for Linux than for Windows).Change a BIOS configuration parameter on each PC.Very basic Linux and networking knowledge would be useful, but not essential. This project does not require and coding or compilation. An Ethernet cable to connect to the local network.Also, there is no information stored locally on each PC for the user to tamper with - if the user messes up a PC, just reboot the PC to return to normal. The cost of each PC is reduced because individual hard disks are not needed. When the PCs are turned on, they will fetch the boot information from a PXE/netboot server. This server allows you to run a number of networked PCs, each without its own hard disk, in a classroom/library/café. 5.4 Configuring the web server on the RPi. ![]() 5.3 Configuring the tftp server on the RPi.5.2 Configuring the DHCP server on the RPi. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |